Rhino command: JewelReassign

All crystal components and pips are associated with a specific surface/geometry. During Jewel Add command and Jewel Edit command this geometry is used to place and orient the component.
If the geometry changes very strongly due to boolean or trimming the association will be lost and the components cannot be edited any more. Also if components are copied they loose their association to the surface. If this happens the components get a red circle during Jewel Edit command and they cannot be moved without being reassigned.

After starting the command components must be selected which should be reassigned. The next step is to select the surface to which the components should be assigned to. At this point a command option SnapOnSurface is available which gives you the same functionality as the Jewel Snap command.