The Centric panel is now scrollable if the window size is smaller than. This ensures that all informations can be viewed even on small monitors.

Creation of Technical 3D was completely reworked. Now it is possible to create a Technical 3D document if there is no Design Document available. It also supports attaching Technical 3D document to existing BOM which was created in Centric.

Adapted the Design to Cost measurement guide for the motif costs.

The Unit of Measure in the BOM panel was taken from the material, not from the BOM line in Centric. Now it corresponds to the BOM view in Centric.

The volume and area calculation was wrong for extrusion objects. Now it also supports this type of geometry

Informations in the Centric panel disappeared when the login happened after the opening of the document.

The drop-down field for the season was empty after login, which is needed to create new design documents. Now the drop-down is filled with all seasons from Centric.

The Design to Cost panel was not cleared after creating a new document. Now the panel and also the cost calculation are cleared if a new document is created.

Scrolling with the mouse in the componentlibrary was not possible, if the Rhino window or the Component panel is on another monitor which is positioned on the left side of the primary monitor. Now the mouse wheel position is calculated correctly and the component panel can be placed everywhere.